Products

>
Products > B200 SERIES CAM CLUTCHES(B203-B214)

B200 SERIES CAM CLUTCHES(B203-B214)

Dimensions and capacities

Model

Max.Torque
(N.m)

Max.Speed
(r/mm)


Inner DiaA H7(mm)

Outer Dia B h7(mm)

Lenth C
(mm)

Keyway
(mm)
Inner Race
Outer Race
B203
39.2
2400
500
16.51
40
25
4.0x2.5
B204
58.8
2400
500
18.796
47
25
5.0x3.0
B205
98
1800
400
23.622
52
25
5.0x3.0
B206
235
1800
350
32.766
62
28
7.0x4.0
B207
372
1800
300
42.088
72
28
7.0x4.0
B208
549
1800
200
46.761
80
32
10.0x4.5
B209
549
1200
200
46.761
85
32
10.0x4.5
B210
784
1200
200
56.109
90
32
10.0x4.5
B211
784
1200
200
56.109
100
32
10.0x4.5
B212
1230
1200
180
70.029
110
42
10.0x4.5
B213
1230
1200
180
70.029
120
42
10.0x4.5
B214
1390
1000
180
79.356
125
42
12.0x4.5

Installation and Usage

1.200 Series Cam Clutches are shaftmounted,so the shaft on which the clutch is mounted must bu hardend to Rc 56-60 and 1.5 mm case depth after grinding. Grind to 1.5s (16micro-inch) finish. The taper of this shaft should not exceed 0.01mm per 50mm.
2.For installation of the clutch, mountthe clutch with bearings at both side on one side in order to obtain concentricty between the shaft and the clutch outer race and to take upradial or thrust loads which may workon the outer race or the shaft. See the installation example.
3.The clutch should be mounted on the shaft by rotating it in the derection marked by the arrow shown on the clutch plate.
Do not apply shock to the clutch by harmmering.
4.The clutches have the same outside diameters as the bearings shouwn in the table above .Bore tolerance of the housing inwhich the clutch is assembled should be within the range shown in the table below.
5.For indexing,oil lubrication is recommended.
6.Concentricity of the housing bore and shaft should be within 0.05mm.
7.Key should be in accordance with JIS B1301-1959

Lubrication
1.Oil lubrication is recommended.
2.Do not use greases or lubricants with EP additives.