1.For installation,insert the clutch into the hub bore of a pulley, agear or atorque arm and screw the bolts (high tension) into
the tapped holes of the end face of the clutch.See illustration on the right.
2.A press fit is required for MX series Clutches for indexing applications, but do not exceed 0.025mm when press fitting.
3.Adjust the side of key to fit the keyway tightly, but make a clearance between the top of key and keyway.
4.,When mounting the clutch on a shaft, apply pressure to the clutch inner race end, but never to the outer race.
5.Proper selection of the Cam Clutch provides accurate indexing performance.A braking device and a back stopping device may
also be required for accurate performance.

Lubrication

1.Oil lubrication is recommended.
2.Do not use grease of lubricants with EP additives.